SYSTEM DESCRIPTION
FUNCTION OF MAIN COMPONENTS
Component | Function |
---|---|
Multiplex tilt and telescopic ECU | This ECU sends a control signal to the tilt motor and telescopic motor, based on signals from each switch, to adjust the steering position. |
Tilt motor (Built-in tilt position sensor) | This motor is activated by a signal from the multiplex tilt and telescopic ECU and adjusts the tilt position. The tilt position sensor in the motor detects the tilt position by counting the number of pulses as the motor rotates. |
Telescopic motor (Built-in telescopic position sensor) | This motor is activated by a signal from the multiplex tilt and telescopic ECU and adjusts the telescopic position. The telescopic position sensor in the motor detects the telescopic position by counting the number of pulses as the motor rotates. |
MANUAL OPERATION
(a) The tilt and telescopic positions can be adjusted as desired by operating the tilt and telescopic switch.
AUTO AWAY/RETURN FUNCTION
(a) When the power source is changed from on (ACC) or on (IG) to off, and the multiplex tilt and telescopic ECU receives a seat belt release signal, the steering wheel automatically tilts up and fully retracts.
(b) When the power source is changed from off to on (ACC) or on (IG), or the multiplex tilt and telescopic ECU receives a seat belt fastened signal, the steering wheel automatically returns to the previous position which was set before the power source was turned off.
(c) The auto away/return function can be prohibited by using the Techstream.
DRIVING POSITION MEMORY FUNCTION (w/ Seat Memory)
(a) The system can memorize/recall three driving positions by operating the seat memory switch LH. Even if these positions are changed when a driver is getting in/out, it can recall the memory position by one-touch operation if the steering wheel column position, seat position and outer mirror surface position of the driver are stored.
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear Center Seat Inner Belt Assembly(w/ Rear No. 2 Seat): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SEAT CENTER BELT ASSEMBLY INNER (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Rear No. 1 center seat belt unfastened Below 1 Ω Rear No. 1 ...
Lexus RX (RX 350L, RX450h) 2016-2024 Owners Manual > Before driving: Cargo and luggage
Take notice of the following information about storage precautions,
cargo
capacity and load.
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capacity) - (Total weight of occupants)
Steps for Determining Correct Load Limit ...