DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1585 | USB Device Malfunction | When any of the following conditions is met:
|
|
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | REPLACE USB DEVICE OR "iPod" |
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the engine switch off.
HINT:
When this DTC has been stored, it is necessary to turn the engine switch off to make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the engine switch on (ACC).
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
Click here
|
| 2. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | | USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
Voice Recognition Microphone Disconnected (B1579)
AV Signal Stoppage (Low Battery Voltage) (B158F)Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Using the air conditioning
system and defogger: Lexus Climate
Concierge
The climate control seats are automatically controlled according to the
set
temperature of the air conditioning system, outside temperature, cabin
temperature,
etc. Lexus Climate Concierge allows a comfortable condition to be
maintained without adjusting each system.
Front automatic air ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Console Box Light (for Console Box Front Side): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY (a) Connect the connector. (b) Engage the 2 claws to install the No. 1 interior illumination light assembly. 2. INSTALL REAR CONSOLE BOX GARNISH Click here 3. INSTALL CONSOLE PANEL SUB-ASSEMBLY Click here 4. INSTALL INS ...