INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. INSTALL STEERING VIBRATION AND HEATER ECU
Click here
2. INSTALL NO. 1 SWITCH WIRE
for U881F: Click here
for U881E: Click here
3. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
for U881F: Click here
for U881E: Click here
4. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
5. INSTALL CRUISE CONTROL MAIN SWITCH
Click here
6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
8. INSTALL STEERING WHEEL ASSEMBLY
| (a) Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly. |
|
(b) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(c) Connect each connector to the spiral cable with sensor sub-assembly.
9. CHECK STEERING WHEEL CENTER POINT
10. INSTALL HORN BUTTON ASSEMBLY
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Television Camera (for Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below. Necessary Procedure After Parts R ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cornering Light Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cornering light assembly (fog light assembly) removal/installation are shown below. Necessary Procedure ...