REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
Lithium Soap Base Glycol Grease |
(b) Install the No. 2 steering rack boot to the groove on the rack housing.
NOTICE:
2. INSTALL NO. 1 STEERING RACK BOOT
HINT:
Perform the same procedure as for the No. 2 steering rack boot.
3. INSTALL NO. 2 STEERING RACK BOOT CLAMP (for LH Side)
(a) Using SST, install a new No. 2 steering rack boot clamp as shown in the illustration. SST: 09521-24010 Clearance: 3.0 mm (0.118 in.) or less NOTICE: Be careful not to damage the No. 2 steering rack boot. | |
4. INSTALL NO. 2 STEERING RACK BOOT CLAMP (for RH Side)
HINT:
Perform the same procedure as for the LH side.
5. INSTALL STEERING RACK BOOT CLIP (for LH Side)
(a) Using pliers, install the steering rack boot clip.
6. INSTALL STEERING RACK BOOT CLIP (for RH Side)
HINT:
Perform the same procedure as for the LH side.
7. INSPECT STEERING GEAR ASSEMBLY
(a) Using SST, rotate the pinion shaft to see if both the left and right steering rack boots expand and contract smoothly. SST: 09616-00020 If both the left and right steering rack boots do not expand and contract smoothly, use new No. 2 steering rack boot clamps and reinstall the steering rack boots. | |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module (C1AB7)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB7 Blind Spot Monitor Slave Module The blind spot monitor sensor RH (slave) detects an internal malfunction Blind sp ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Theft Deterrent System: Theft Warning Siren Circuit
DESCRIPTION The theft warning siren assembly sounds if either of the following conditions is met:
The theft deterrent system is in the alarm sounding state.
The theft warning siren assembly is in the armed state when the power source, ground or communication line is open.
WIRING DIAGRAM CAU ...