Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Fail-safe Chart

HINT:

• If the power steering assist stops, the EPS warning light comes on (red).
• If the amount of power assist is reduced, the EPS warning light comes on (yellow) and a vibration or sound may occur.
• The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or being driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal when the steering wheel is not turned for approximately 10 minutes with the engine idling.
• If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns to normal when the battery voltage recovers.

EPS Warning Light Circuit

DESCRIPTION If the power steering ECU assembly detects a malfunction, the power steering ECU assembly stores a DTC and illuminates the EPS warning light. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTIC ...

Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA NOTICE: It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measur ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Inner Belt Assembly(for Captain Seat Type): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 f ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Telematics System: Operation Check
OPERATION CHECK DCM OPERATION HISTORY HINT: This function shows the telematics network status when the DCM (telematics transceiver) was operated. Use this when no DTC is present but this telematics system was unable to connect to the call center. This symptom may occur if cell phone signal streng ...