INSTALLATION
PROCEDURE
1. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Temporarily install the stop light switch assembly with stop light switch lock nut as shown in the illustration.
*a | Stop Light Switch Lock Nut |
![]() | Install in this Direction |
(b) Turn the stop light switch assembly so that the clearance between the end of the threads and the cushion is within (A).
|
|
(c) Tighten the stop light switch lock nut.
Torque:
16.7 N·m {170 kgf·cm, 12 ft·lbf}
(d) Connect the connector.
(e) If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.
Click here
NOTICE:
Do not depress or support the brake pedal.
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Camera: Before Starting Adjustment
BEFORE STARTING ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Can Communication System: Check Bus 3 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the network gateway ECU and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the network gateway ECU and terminal 4 (CG) of the DLC3. Symptom Trouble A ...