Components
COMPONENTS
ILLUSTRATION
| *1 | LOWER STEERING COLUMN COVER | *2 | MULTIPLEX TILT AND TELESCOPIC ECU |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
Installation
INSTALLATION
PROCEDURE
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Engage the claw to install the multiplex tilt and telescopic ECU.
| Install in this direction |
(b) Connect the connector.
2. INSTALL LOWER STEERING COLUMN COVER
Click here
3. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
Removal
REMOVAL
PROCEDURE
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
Click here
2. REMOVE LOWER STEERING COLUMN COVER
Click here
3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the connector.
| *a | Protective Tape |
| Remove in this direction |
(b) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the multiplex tilt and telescopic ECU.
Terminals Of EcuLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seatback Heater (for 60/40 Split Seat Type Lh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback heater removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Pressure Sensor Difference for Front Door (B166A)
DESCRIPTION The door side airbag sensor LH and door side airbag sensor RH detect impacts to the vehicle through changes in pressure inside the front doors caused by deformation of the outer side of the front doors and send signals to the airbag sensor assembly. Based on the signals sent by the door ...