DESCRIPTION
The ECU power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2620 | ECU Power Source Circuit Malfunction | The voltage of the ECU power source drops to 8 V or less and this condition continues for 10 seconds or more. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
HINT:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY) |
| (a) Disconnect the J25 multiplex tilt and telescopic ECU connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J25-9 (ECUB) - Body ground | Always | 11 to 14 V |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
| 2. | CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
| (a) Disconnect the J25 multiplex tilt and telescopic ECU connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J25-8 (GND2) - Body ground | Always | Below 1 Ω |
| OK | | REPLACE MULTIPLEX TILT AND TELESCOPIC ECU |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Telescopic Position Sensor or Telescopic Motor Circuit Malfunction (B2611)
Vehicles Speed Malfunction (B2624)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: Power Source Control ECU Malfunction (B2782)
DESCRIPTION The certification ECU (smart key ECU assembly) has a power source mode switching function. This DTC is stored when the IGE input (the steering lock motor activation permission signal) sent directly from the certification ECU (smart key ECU assembly) to the steering lock ECU (steering loc ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Conditioning Pressure Sensor: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONER PRESSURE SENSOR (a) Check the wire harness. (1) Disconnect the A9 air conditioner pressure sensor connector. (2) Disconnect the J42 air conditioning amplifier assembly connector. (3) Measure the resistance according to the value(s) in the ta ...