REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL GARNISH LH
Click here
2. REMOVE FRONT DOOR SCUFF PLATE LH
w/ Rear No. 2 Seat: Click here
w/o Rear No. 2 Seat: Click here
3. REMOVE COWL SIDE TRIM BOARD LH
Click here
4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
7. REMOVE STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
| (a) Disengage the 4 claws to remove the steering heater switch (integration control and panel assembly). |
|
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Initialization
INITIALIZATION NOTICE:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 headlight ECU sub-assembly LH removal/installation are shown below. Replaced Part or Performed Proced ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Drive Belt: Installation
INSTALLATION PROCEDURE 1. INSTALL V-RIBBED BELT (a) Install the V-ribbed belt. NOTICE:
Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.
Check that the V-ribbed belt is properly set to each pulley.
...