Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE STEERING RACK BOOT CLIP (for LH Side)

(a) Using pliers, remove the steering rack boot clip.

2. REMOVE STEERING RACK BOOT CLIP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

3. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side)

(a) Using a screwdriver, remove the No. 2 steering rack boot clamp.

NOTICE:

Be careful not to damage the No. 2 steering rack boot.

4. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

5. REMOVE NO. 2 STEERING RACK BOOT

6. REMOVE NO. 1 STEERING RACK BOOT

    Components
    COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 NO. 2 ENGINE UNDER COVER *2 STEERING INTERMEDIATE SHAFT ASSEMBLY *3 TIE ROD ASSEMBLY LH *4 COTTER PIN T ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH (a) Secure the tie rod assembly LH in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Install the nut to the ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Adjusting the steering wheel and mirrors: Outside rear view mirrors
    Adjustment procedure 1. To select a mirror to adjust, press the switch. Left Right Pressing the same switch again will put the switch in neutral. 2. To adjust the mirror, press the switch. Up Right Down Left Folding the mirrors (manual type) Push the mirror back in the ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lumbar Switch: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below. Necessary Procedures After Parts Re ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0152