INSPECTION
PROCEDURE
1. INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY
(a) Check the operation of the fuel lid lock with motor assembly.
| (1) Apply battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows. OK:
If the result is not as specified, replace the fuel lid lock with motor assembly. |
|
(2) Measure the shaft stroke.
OK:
| Area | Condition | Specified Condition |
|---|---|---|
| Shaft stroke | Lock | 11 +/- 1.4 mm (0.433 +/- 0.055 in.) |
| Unlock | 0 mm (0 in.) |
If the result is not as specified, replace the fuel lid lock with motor assembly.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Door Belt Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below. Necessary Procedures After Parts Removed/ ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intelligent Clearance Sonar System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...