Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

ICS SW Status

Intelligent clearance sonar system switch assembly (Multi-information switch)

OFF or ON

OFF: Intelligent clearance sonar system off

ON: Intelligent clearance sonar system on

-

Fr Sensor Onset Range

Detection operation range (for front center sensors)

Narrow or Wide

Narrow: 600 mm (23.6 in.)

Wide: 1000 mm (39.4 in.)

Customized value displayed

Rr Sensor Onset Range

Detection operation range (for rear center sensors)

Narrow or Wide

Narrow: 600 mm (23.6 in.)

Wide: 1500 mm (59.1 in.)

Customized value displayed

Fr & Rr Buzzer Volume

Buzzer volume setting

L, M or H

L: Low volume

M: Medium volume

H: High volume

Customized value displayed

Sensor Condition N

Front sensor operation

Not Avail or Avail

Not Avail: Front sensors not available

Avail: Front sensors available

Customized value displayed

Approach Display OFF

Whether the display turns off after an obstacle is no longer detected.

Not Avail or Avail

Not Avail: Not displayed

Avail: Displayed

Customized value displayed

Fr Corner Sensor Onset Range

Sets the detection operation range for the front corner sensors.

Short or Long

Short: 450 mm (17.7 in.)

Long: 600 mm (23.6 in.)

Customized value displayed

Rr Corner Sensor Onset Range

Sets the detection operation range for the rear corner sensors.

Short or Long

Short: 450 mm (17.7 in.)

Long: 600 mm (23.6 in.)

Customized value displayed

Intuitive P/A Judgement of Obstacle on Course

Availability of judgement of obstacle on course.

Valid or Invalid

Valid: Judgement of obstacle on course is valid

Invalid: Judgement of obstacle on course is invalid

Customized value displayed

Target 1 Distance (FLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (FRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (RLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (RRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (FL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (FR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (RL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (RR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (FLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (FRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (RLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (RRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (FL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (FR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (RL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (RR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

ICS Function

Current setting of intelligent clearance sonar system

ON or OFF

ON: Intelligent clearance sonar system enabled

OFF: Intelligent clearance sonar system disabled

Customized value displayed

ICS System

Existence of intelligent clearance sonar system

Without or With

Without: w/o Intelligent clearance sonar system

With: w/ Intelligent clearance sonar system

-

ICS Stop Distance

Target stop distance

Short or Long

Short: Near

Long: Far

Customized value displayed

ICS SW Status Memory

Setting that determines if the on/off operation state when the engine switch is turned off is resumed when the engine switch is turned on

Yes or No

Yes: Previous on/off operation state is resumed

No: System operates when the engine switch is turned on

Customized value displayed

Bumper Type

Registered bumper type

Unfixed or 1 to 127

2: Bumper for Sport Package

3: Bumper for except Sport Package

1, 4 to 127: Unknown

Unfixed: Unknown

-

# Codes

Number of stored DTCs

min.: 0, max.: 255

Number of DTCs will be displayed

-

(f) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Data List.

(g) According to the display on the Techstream, read the Data List.

Chassis > ABS/VSC/TRAC/EPB > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Stop Light SW

Stop light switch assembly

ON or OFF

OFF: Brake pedal released

ON: Brake pedal depressed

-

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Chassis > ABS/VSC/TRAC/EPB > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Stop Light Relay

Stop lights

ON / OFF

Test possible at vehicle speed of 0 km/h (0 mph)

(f) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(g) According to the display on the Techstream, perform the Active Test.

Body Electrical > Combination Meter > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

ICS OFF Indicator

ICS OFF indicator light

ON / OFF

-

(h) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Active Test.

(i) According to the display on the Techstream, perform the Active Test.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Front Buzzer

No. 1 clearance warning buzzer

Stop or Operate

Confirm that the vehicle is stopped and the engine switch is on (IG)

Rear Buzzer

No. 2 clearance warning buzzer

Stop or Operate

Confirm that the vehicle is stopped and the engine switch is on (IG)

Front/Rear Buzzer

No. 1 clearance warning buzzer and No. 2 clearance warning buzzer

Stop or Operate

Confirm that the vehicle is stopped and the engine switch is on (IG)

    Fail-safe Chart
    FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the intelligent clearance sonar system, the warning message "Parking Support Brake Malfunction Visit Your Dealer" or "Parking Sup ...

    ECU Malfunction (C1611)
    DESCRIPTION If the clearance warning ECU assembly detects an internal malfunction during self-diagnosis, DTC C1611 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Fuel Pressure Sensor: Installation
    INSTALLATION PROCEDURE 1. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR) HINT: Perform "Inspection After Repair" after replacing the fuel delivery pipe sub-assembly (fuel pressure sensor). Click here Click here NOTICE: Do not remove the fuel pressure sensor from the fuel deli ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Front Camera: Adjustment (sequential Recognition)
    ADJUSTMENT (SEQUENTIAL RECOGNITION) CAUTION / NOTICE / HINT NOTICE: Make sure to read Before Starting Adjustment before proceeding with work. Click here PROCEDURE 1. SECURE APPROPRIATE AREA FOR PERFORMING LEARNING (a) Park the vehicle on a level surface. HINT: Make sure that the target recog ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0171