Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: ECU Malfunction (C1611)

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intelligent Clearance Sonar System / ECU Malfunction (C1611)

DESCRIPTION

If the clearance warning ECU assembly detects an internal malfunction during self-diagnosis, DTC C1611 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1611

ECU Malfunction
  • Sub-CPU abnormal signal
  • Mirror check abnormal

Clearance warning ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  • After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

    Click here

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Using the Techstream, check for DTCs according to the prompts on the screen.

Click here

HINT:

After turning the engine switch from off to on (IG), wait 3 seconds or more before checking for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

(b) Clear the DTCs according to the screen on the Techstream.

Click here

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(c) Recheck for DTCs.

Click here

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

DTC C1611 is output

A

DTC C1611 is not output

B
A

REPLACE CLEARANCE WARNING ECU ASSEMBLY

B

USE SIMULATION METHOD TO CHECK

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa ...

    Open or Short in Steering Angle Sensor +B (C1625)
    DESCRIPTION This DTC is stored if the clearance warning ECU assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem. DTC No. Detection Item ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Operation Check
    OPERATION CHECK OPERATION CONDITION NOTICE: This check is possible only when the "System Settings" customize setting is set to ON on the multi-information display in the combination meter assembly. (The default setting is ON.) Click here The operation check below is based on the non-customize ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Knock Sensor: Inspection
    INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 25°C (77°F) 120 to 280 kΩ If the result is not as specified, replace the k ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.012