REMOVAL
PROCEDURE
1. REMOVE BACK WINDOW UPPER PANEL TRIM (w/o Rear No. 2 Seat)
Click here
2. REMOVE BACK WINDOW UPPER PANEL TRIM (w/ Rear No. 2 Seat)
Click here
3. REMOVE BACK DOOR TRIM COVER LH (w/o Rear No. 2 Seat)
Click here
4. REMOVE BACK DOOR TRIM COVER LH (w/ Rear No. 2 Seat)
Click here
5. REMOVE BACK DOOR TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
6. REMOVE BACK DOOR LOCK COVER (w/o Rear No. 2 Seat)
Click here
7. REMOVE BACK DOOR LOCK COVER (w/ Rear No. 2 Seat)
Click here
8. REMOVE BACK DOOR TRIM BASE
Click here
9. REMOVE DOOR PULL HANDLE
Click here
10. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
11. REMOVE BACK DOOR TRIM PANEL ASSEMBLY (w/o Rear No. 2 Seat)
Click here
12. REMOVE BACK DOOR TRIM PANEL ASSEMBLY (w/ Rear No. 2 Seat)
Click here
13. REMOVE POWER BACK DOOR WARNING BUZZER
| (a) Disconnect the connector. |
|
(b) Disengage the clamp to remove the power back door warning buzzer.
Installation
Rear DoorLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Drive Shaft Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Tilt And Power Telescopic Steering Column System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Tilt & Telescopic / Trouble Codes. Body Electrical > Tilt&Telescopic > Tr ...