CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
HINT:
Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in-vehicle device.
PROCEDURE
| 1. | CHECK OPERATION |
(a) Check if the portable player operates normally.
OK:
The portable player operates normally.
| NG | | MALFUNCTION IN PORTABLE PLAYER |
|
| 2. | CHECK AUDIO SETTINGS |
(a) Set volume, fader and balance to the initial values and check that the sound is normal.
OK:
Audio system returns to normal.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
|
| 3. | CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the "Bluetooth" audio player plays normally on another "Bluetooth" audio compatible vehicle of the same model.
OK:
"Bluetooth" audio player plays normally.
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | MALFUNCTION IN PORTABLE PLAYER |
Sound of Portable Player cannot be Heard from Speakers or Sound is Low
Noise Occurs or Sound Skips when Portable Player PlaysLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Switch Lights of Remote Touch Always Illuminate or cannot be Controlled Using Rheostat
DESCRIPTION Power is supplied to the remote touch (remote operation controller assembly) switch illumination when the light control switch is in the tail or head position. HINT:
When the remote touch (remote operation controller assembly) is in self-diagnostic mode, its switch illumination may re ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Initialization
INITIALIZATION INITIALIZE MULTIPLEX NETWORK DOOR ECU NOTICE: Initialization of the multiplex network door ECU (back door initial position learning) is necessary if any of the following have been performed with the back door open.
The cable is disconnected from the negative (-) battery terminal.
...