INSTALLATION
PROCEDURE
1. INSTALL SIDE REAR SPOILER PROTECTOR SUB-ASSEMBLY LH
(a) Install 3 new clips to the side rear spoiler protector sub-assembly LH.
(b) Engage the 4 clips as shown in the illustration to install the side rear spoiler protector sub-assembly LH.
Install in this Direction |
2. INSTALL SIDE REAR SPOILER PROTECTOR SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL REAR SPOILER SUB-ASSEMBLY (w/o Rear No. 2 Seat)
(a) When reusing the rear spoiler sub-assembly:
(1) Wipe off any adhesive residue with cleaner.
(b) Engage the 6 clips as shown in the illustration to install the rear spoiler sub-assembly.
Install in this Direction |
(c) Apply adhesive to the threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(d) Install the rear spoiler sub-assembly with the 4 bolts and 3 nuts.
Torque:
6.6 N·m {67 kgf·cm, 58 in·lbf}
(e) Install the 2 hole plugs.
(f) Connect the 2 connectors.
4. INSTALL REAR SPOILER SUB-ASSEMBLY (w/ Rear No. 2 Seat)
(a) When reusing the rear spoiler sub-assembly:
(1) Wipe off any adhesive residue with cleaner.
(b) Engage the 7 clips as shown in the illustration to install the rear spoiler sub-assembly.
Install in this Direction |
(c) Apply adhesive to the threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(d) Install the rear spoiler sub-assembly with the 4 bolts and 3 nuts.
Torque:
6.6 N·m {67 kgf·cm, 58 in·lbf}
(e) Install the 2 hole plugs.
(f) Connect the 2 connectors.
5. INSTALL BACK WINDOW UPPER PANEL TRIM (w/o Rear No. 2 Seat)
Click here
6. INSTALL BACK WINDOW UPPER PANEL TRIM (w/ Rear No. 2 Seat)
Click here
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Heated Oxygen Sensor: Components
COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 HEATED OXYGEN SENSOR (for Bank 1) *2 HEATED OXYGEN SENSOR (for Bank 2) *3 FRONT EXHAUST PIPE ASSEMBLY *4 FRONT FLOOR COVER LH *5 FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY *6 EXHAUST PIPE GASKET *7 C ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Driving Support Buzzer: Installation
INSTALLATION PROCEDURE 1. INSTALL SKID CONTROL BUZZER ASSEMBLY (a) Connect the connector. HINT: Make sure to install the skid control buzzer assembly in the correct direction. (b) Engage the clamp to install the skid control buzzer assembly. NOTICE: If the skid control buzzer assembly ...