INSPECTION
PROCEDURE
1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (AUTOMATIC HIGH BEAM SWITCH)
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the integration control and panel assembly (automatic high beam switch). |
|
(b) Illumination Inspection
(1) Apply battery voltage to the integration control and panel assembly (automatic high beam switch) off and check that the switch illuminates.
OK:
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 7 (ILL+) Battery negative (-) → Terminal 12 (ILL-) | Illuminates |
If the result is not as specified, replace the integration control and panel assembly (automatic high beam switch).
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting (int): Vanity Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. SEPARATE VANITY LIGHT ASSEMBLY (a) Using a moulding remover, disengage the claw to separate the vanity light assembly. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Theft Deterrent System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here HINT:
Troubleshooting of the theft deterrent system is based on the premise that the power door lock control system and the wireless door lock control system are o ...