REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cornering light assembly (fog light assembly) removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic view monitor system | |
| Front bumper assembly (w/ Intelligent clearance sonar system) |
|
| |
HINT:
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE FRONT BUMPER ARM HOLE COVER LH (for LH Side)
for Type A:
Click here
for Type B:
Click here
3. REMOVE CORNERING LIGHT ASSEMBLY (FOG LIGHT ASSEMBLY)
Click here
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Parking Assist Monitor System: ECU Malfunction (C1611)
DESCRIPTION This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check. HINT: The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open (P032515,P033015)
DESCRIPTION Refer to DTC P032511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P032515 Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open The knock control sensor (bank 1) output voltage is higher than 4.5 V for ...