DESCRIPTION
This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.
HINT:
The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1611 | ECU Malfunction | When one of the following conditions is met:
| Rear television camera assembly |
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | READ VALUE USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Rear Camera / Data List.
(e) Read the Data List according to the display on the Techstream.
Chassis > Rear Camera > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Video Output Status | Output condition of video signal | OK or NG | OK: Output condition of video signal is normal NG: Output condition of video signal is abnormal | - |
| EEPROM Status (Initial read) | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal | - |
| CPU Communication Status | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal | - |
| Tester Display |
|---|
| Video Output Status |
| EEPROM Status (Initial read) |
| CPU Communication Status |
| Result | Proceed to |
|---|---|
| OK is displayed for all items | A |
| NG is displayed for EEPROM status (Initial read) | |
| NG is displayed for items other than EEPROM status (Initial read) | B |
| B | | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
|
| 2. | PERFORM CALIBRATION |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
(1) Rear television camera assembly optical axis adjustment (back camera position setting).
Click here
(2) Steering angle setting.
Click here
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Recheck for DTCs and check that no DTCs are output.
Click here
HINT:
| Result | Proceed to |
|---|---|
| DTC C1611 is output | A |
| DTC C1611 is not output | B |
| A | | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
| B | | END |
Dtc Check / Clear
Back Camera Power Supply Failure (C1621)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Parking Assist Monitor System: Calibration
CALIBRATION ADJUST PARKING ASSIST MONITOR SYSTEM (a) The parking assist monitor system can be adjusted using diagnostic mode. (b) If the following operations are performed, it is necessary to perform adjustments and checks using diagnostic mode. Part Name Operation Adjustment Item Proceed t ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: System Description
SYSTEM DESCRIPTION SYSTEM DESCRIPTION (a) The Electronic Controlled Automatic Transaxle (ECT) is an automatic transaxle that electronically controls shift timing using the ECM. The ECM detects electrical signals that indicate engine and driving conditions, and controls shift points based on driver h ...