Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE

1.

START DIAGNOSTIC MODE

(a) Enter diagnostic mode and check if the "Service Menu" screen can be displayed.

Click here

OK:

Diagnostic mode can be activated.

NG

GO TO STEP 3

OK

2.

CHECK PANEL SWITCH (OPERATION CHECK)

(a) Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.

Click here

(b) Operate the abnormal switch and check if the switch status is correctly displayed.

OK:

The switch status is correctly displayed as operated.

OK

REPLACE RADIO RECEIVER ASSEMBLY

NG

GO TO STEP 3

3.

REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (SWITCH OPERATION CHECK)

(a) Activate self-diagnostic mode.

Click here

(b) Operate the remote touch screen in the upper left to turn the switch illumination off.

NOTICE:

Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode.

*a

Switch Illumination

*b

Remote Touch Screen

(c) With the switch illumination turned off, press each switch of the remote touch (remote operation controller assembly) and check that the switch illumination turns on.

Result

Proceed to

Self check mode cannot be activated.

A

Some switches do not turn on the switch illumination when they are pressed.

All switches turn on the switch illumination when they are pressed.

B

A

REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY)

B

REPLACE RADIO RECEIVER ASSEMBLY

    Switch Lights of Remote Touch Always Illuminate or cannot be Controlled Using Rheostat
    DESCRIPTION Power is supplied to the remote touch (remote operation controller assembly) switch illumination when the light control switch is in the tail or head position. HINT: When the remote tou ...

    Pointer Displayed/not Displayed Repeatedly
    WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be need ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Sfi System: Evaporative Emission System Pressure Sensor/Switch Circuit Short to Ground (P045011,P045015,P04502A,P04502F)
    DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P045011 Evaporative Emission System Pressure Sensor/Switch Circuit Short to Ground EVAP pressure less than 42.11 kPa(abs) [6.11 psi(abs)] for 0.5 seconds. Canister pump module Wire h ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Vacuum Switching Valve (for Acis): Removal
    REMOVAL PROCEDURE 1. REMOVE V-BANK COVER SUB-ASSEMBLY Click here 2. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) (a) Disconnect the No. 1 vacuum switching valve assembly (for ACIS) connector. (b) Disconnect the 2 vacuum hose assemblies from the No. 1 vacuum switching v ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0144