Lexus RX (RX 350L, RX450h) 2016-2024 Owners Manual: Menu icons

Select a menu icon to display its content.

Drive information

Select to display various drive data.

Navigation system-linked display (if equipped)

Select to display the following navigation system-linked information.

• Route guidance

• Compass display (heading-up display)

Audio system-linked display

Select to enable selection of an audio source or track on the meter using the meter control switches.

Driving assist system information

Select to display the operational status of the following systems:

• Dynamic radar cruise control with full-speed range

• LKA (Lane-Keeping Assist)

Warning message display

Select to display warning messages and measures to be taken if a malfunction is detected.

Settings display

Select to change the meter display settings and other settings.

Drive information ()

■ Drive information 1/Drive information 2/Drive information 3

Displays drive information such as the following:

• Drive information 1

  • Current fuel consumption

  • Average fuel economy (after reset)

• Drive information 2

  • Distance (driving range)

  • Average vehicle speed (after reset)

• Drive information 3

  • Average fuel economy (after refuel)

  • Elapsed time (after start)

Displayed items (listed below) can be changed on .

*1: Resetting.
*2: Use the displayed fuel consumption as a reference.
*3: When only a small amount of fuel is added to the tank, the display may not be updated.
When refueling, turn the power switch off. If the vehicle is refueled without turning the power switch off, the display may not be updated.
*4: This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.

■ Sway warning Detects the sway of the vehicle within a lane, which is often associated with a decrease in the driver's attention level, and displays the decrease in attention using a bar display.

The shorter the bar length, the more the driver may need to rest.

This display is a part of the LKA (Lane-Keeping Assist) system. The display is enabled when the operating conditions of the vehicle sway warning are met.

■ AWD Control Displays the driving force applied to each wheel using segments.

The greater the number of segments displayed, the greater the driving force applied.

■ G-force (if equipped) Displays lateral G-forces on the vehicle.

Also displays, around the periphery of the G-force display, the left and right steering amount, accelerator pedal input, and brake fluid pressure.

1. Acceleration G-force on the vehicle
2. Current G-force value (analyzed value of front/rear and left/right G-forces)
3. Record of the maximum G-forces
4. Accelerator pedal input
5. Brake fluid pressure
6. Steering amount

This display is intended for use as a guideline. Depending on factors such as the road surface condition, temperature and vehicle speed, the display may not show the actual condition of the vehicle.

• Resetting the record of maximum G-forces
  Press and hold to reset the record.
• Peak hold function
  If lateral G-forces of 0.5 G or greater are generated, the G-force value display will turn amber and be held for 2 seconds.

■ Units (if equipped) The units of measure used can be changed while driving.

Unlike the units setting performed on , the units setting performed on can be changed while driving.

■ Blank (No items) Displays no drive information contents.

Settings display ()

Changing settings

Use the meter control switches on the steering wheel to change settings.

1. Press or to select .

2. Operate the switches to select a desired item.

3. Change the setting by referring to the message displayed on the screen.

Setting items

  LKA (Lane-Keeping Assist)

The following LKA system settings can be changed:

*1: If the lane centering function is enabled/disabled, steering wheel assistance will also be enabled/disabled accordingly.
*2: If the steering wheel assistance is disabled, lane centering function will also be disabled automatically.

PCS (Pre-Collision System)

The following pre-collision system settings can be changed:

BSM (Blind Spot Monitor) (if equipped)

The following Blind Spot Monitor settings can be changed:

*: The Rear Cross Traffic Alert function can be enabled/disabled only when the Blind Spot Monitor function is enabled.

Intuitive parking assist (if equipped)

ICS (Intelligent Clearance Sonar) (if equipped)

HUD (Head-up display) (if equipped)

The following head-up display settings can be changed:

Clock (on the multi-information display)

Vehicles with a navigation system

The following clock setting can be changed:

Vehicles with a Lexus Display Audio system

The following clock settings can be changed:

Press the switch to select an item and then press the switch to change the setting or adjust the time.

Vehicle settings

Meter settings

Odometer/trip meter display area

Display items

■ Odometer Displays the total distance the vehicle has been driven.

■ Trip meter A/trip meter B Displays the distance the vehicle has been driven since the meter was last reset. Trip meters A and B can be used to record and display different distances independently.

To reset, display the desired trip meter and press and hold the "ODO/TRIP" switch.

■ Distance until next engine oil change Displays the distance the vehicle can be driven until an oil change is necessary.

Pop-up display

In some situations the following will be temporarily displayed:

■ Distance until next engine oil change Displays the distance until the next engine oil change. This display will be displayed in the following situations:

• When the power switch is turned to ON mode.
• When a warning message indicating that oil maintenance should be performed soon or is required is displayed.

Suggestion function

Displays suggestions to the driver in the following situations. To select a response to a displayed suggestion, use the meter control switches.

The suggestion function can be turned on/off.

■ Suggestion to enable the power back door If the power back door system is disabled (setting on set to off) and the power back door switch on the instrument panel is operated, a suggestion message will be displayed asking if you wish to enable the power back door system. To enable the power back door system, select "Yes".

After enabling the power back door system, press the power back door switch again to open or close the power back door.

■ Suggestion to turn off the headlights If the headlights are left on for a certain amount of time after the power switch has been turned off, a suggestion message will be displayed asking if you wish to turn the headlights off. To turn the headlights off, select "Yes".

If a front door is opened after the power switch is turned off, this suggestion message will not be displayed.

■ Background color of the indicator/shift position display area (except F SPORT models) The background color of the indicator/shift position display area is changed according to the driving mode as follows

• Eco drive mode: Blue

• Sport mode: Red

■ G-force display (if equipped)

• The G-force values may not be zero even when the vehicle is parked, such as when it is parked on an incline.

• Depending on the vehicle usage conditions, the brake fluid pressure display may not reach its maximum reading even though the brake pedal is fully depressed.

• If a 12-volt battery terminal is disconnected and reconnected, the steering amount display may be disabled temporarily. After driving the vehicle for a while, the display will be enabled.

■ Suspension of the settings display

• Some settings cannot be changed while driving. When changing settings, park the vehicle in a safe place.

• If a warning message is displayed, operation of the settings display will be suspended.

■ Tire pressure

• It may take a few minutes to display the tire inflation pressure after the power switch is turned to ON mode. It may also take a few minutes to display the tire inflation pressure after inflation pressure has been adjusted.

• "---" may be displayed if the tire position information cannot be determined due to unfavorable radio wave conditions.

• Tire inflation pressure changes with temperature. The displayed values may also be different from the values measured using a tire pressure gauge.

■ Liquid crystal display Small spots or light spots may appear on the display. This phenomenon is characteristic of liquid crystal displays, and there is no problem continuing to use the display.

■ Customization Some functions can be customized.

WARNING

■ Caution for use while driving

• When operating the multi-information display while driving, pay extra attention to the safety of the area around the vehicle.
• Do not look continuously at the multi-information display while driving as you may fail to see pedestrians, objects on the road, etc. ahead of the vehicle.

■ The information display at low temperatures Allow the interior of the vehicle to warm up before using the liquid crystal information display. At extremely low temperatures, the information display monitor may respond slowly, and display changes may be delayed.

■ Cautions during setting up the display As the hybrid system needs to be operating during setting up the display, ensure that the vehicle is parked in a place with adequate ventilation. In a closed area such as a garage, exhaust gases including harmful carbon monoxide (CO) may collect and enter the vehicle. This may lead to death or a serious health hazard.

NOTICE

■While setting up the display To prevent 12-volt battery discharge, ensure that the hybrid system is operating while setting up the display features.