DESCRIPTION
The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system |
| Main Body |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
HINT:
If the forward recognition camera stores a DTC for a malfunction of any of the following, this DTC will be stored simultaneously.PROCEDURE
| 1. | CHECK FOR DTC (HEALTH CHECK) |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: System Select / Health Check.
(e) Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
| B | | GO TO OTHER DTC CHART |
|
| 2. | CHECK FRONT CAMERA SYSTEM |
(a) Check if a dynamic radar cruise control system, lane control system, road sign assist system* or pre-collision system warning message is displayed on the multi-information display.
Click here
OK:
No dynamic radar cruise control system, lane control system, road sign assist system* or pre-collision system warning messages are displayed.
| OK | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | | GO TO FRONT CAMERA SYSTEM |
Vehicle Control History
Light Sensor Circuit (B1244)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cooling Fan Motor: On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when inspecting the cooling fan system. PROCEDURE 1. INSPECT COOLING FAN MOTOR RH CAUTION: To prevent injury due to contact ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Inner Belt Assembly(for Rh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat inner belt assembly removal/installation are shown below. Necessary Procedure After Parts Remo ...