DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
(a) Disconnect the J169 radio receiver assembly connector.
(b) Disconnect the J170 No. 1 stereo jack adapter assembly connector.
| (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Speaker Circuit
AVC-LAN CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Brake Booster: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake booster assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Opening, closing and locking the doors: Power back door
The power back door can be locked/unlocked and opened/closed by the
following
procedures.
Locking and unlocking the power back door from the outside
Smart access system with push-button start
Carry the electronic key to enable
this function.
Locks all the doors
Check that the door is se ...