INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
| (a) Engage the 2 guides and claw. |
|
(b) Temporarily install the outer rear view mirror assembly with the 3 nuts.
(c) Tighten the 3 nuts in the order shown in the illustration.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
2. INSTALL OUTER MIRROR INSTALL HOLE COVER
(a) Engage the 2 claws to install the outer mirror install hole cover.
(b) Install the 2 screws.
(c) w/o Panoramic View Monitor System:
(1) Engage the 3 clamps.
(2) Connect the connector.
(d) w/ Panoramic View Monitor System:
(1) Engage the 3 clamps.
(2) Connect the 2 connectors.
3. INSTALL OUTER MIRROR PROTECTOR
(a) Install 2 new outer mirror protectors.
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
5. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION
Click here
6. INSTALL COURTESY LIGHT ASSEMBLY
Click here
7. INSTALL DOOR ARMREST COVER
Click here
8. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
9. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
Click here
11. PERFORM INITIALIZATION (w/ Panoramic View Monitor System)
Click here
12. ADJUST SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Click here
Disassembly
ReassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Immobiliser System: Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid (B279986)
DESCRIPTION If there is a communication malfunction between the ECM and ID code box (immobiliser code ECU), or when the communication ID codes do not match, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279986 Engine Immobiliser System Si ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Drive Shaft Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remov ...