DESCRIPTION
When the mirror heater switch (rear window defogger switch) is operated, the mirror heater signal is sent to the air conditioning amplifier assembly and then to each outer mirror control ECU assembly via CAN communication. Based on this signal, the outer mirror control ECU assemblies operate the mirror heaters.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
Click here
PROCEDURE
1. | CHECK WINDOW DEFOGGER SYSTEM |
(a) Check window defogger system operation.
Click here
OK:
Window defogger system is normal.
NG | ![]() | GO TO WINDOW DEFOGGER SYSTEM |
|
2. | PERFORM ACTIVE TEST USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Mirror L or Mirror R / Active Test.
(e) Perform an Active Test according to the display on the Techstream.
Body Electrical > Mirror L > Active Test Tester Display | Measurement Item | Control Range | Diagnostic Note |
---|---|---|---|
Mirror Heater | Mirror heater operation | OFF or ON |
|
Tester Display |
---|
Mirror Heater |
Tester Display | Measurement Item | Control Range | Diagnostic Note |
---|---|---|---|
Mirror Heater | Mirror heater operation | OFF or ON |
|
Tester Display |
---|
Mirror Heater |
Result | Proceed to |
---|---|
Mirror heater operation on both mirrors is normal | A |
Mirror heater operation on driver door mirror is not normal | B |
Mirror heater operation on front passenger door mirror is not normal | C |
A | ![]() | REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
C | ![]() | GO TO STEP 5 |
|
3. | INSPECT OUTER REAR VIEW MIRROR ASSEMBLY (DRIVER DOOR) (MIRROR HEATER) |
(a) Remove the outer rear view mirror assembly (driver door).
Click here
(b) Remove the outer rear view mirror assembly (driver door) (mirror heater).
Click here
OK | ![]() | REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) |
|
4. | INSPECT OUTER MIRROR (DRIVER DOOR) |
(a) Remove the outer mirror (driver door).
Click here
(b) Inspect the outer mirror (driver door).
Click here
OK | ![]() | REPLACE OUTER REAR VIEW MIRROR ASSEMBLY (DRIVER DOOR) |
NG | ![]() | REPLACE LH MIRROR OUTER |
5. | INSPECT OUTER REAR VIEW MIRROR ASSEMBLY (FRONT PASSENGER DOOR) (MIRROR HEATER) |
(a) Remove the outer rear view mirror assembly (front passenger door).
Click here
(b) Remove the outer rear view mirror assembly (front passenger door) (mirror heater).
Click here
OK | ![]() | REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FRONT PASSENGER DOOR) |
|
6. | INSPECT OUTER MIRROR (FRONT PASSENGER DOOR) |
(a) Remove the outer mirror (front passenger door).
Click here
(b) Inspect the outer mirror (front passenger door).
Click here
OK | ![]() | REPLACE OUTER REAR VIEW MIRROR ASSEMBLY (FRONT PASSENGER DOOR) |
NG | ![]() | REPLACE RH OUTER MIRROR (OUTER MIRROR (FRONT PASSENGER DOOR)) |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Brake: Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time. PROCEDURE 1. REMOVE FRONT DISC BRAKE PISTON (a) Place a piece of cloth and a wooden block between the front disc brake piston and front ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Installation
INSTALLATION PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned. HINT: After adjusting the toe-in, tighten the lock nut. *a Matchmark 2. INSTALL TIE ROD ASSEMBLY RH HINT: ...