DESCRIPTION
This DTC will be stored if the operation of the sliding roof or roof sunshade is suspended and a pulse input of 10 Hz or more is detected when the motor relay is off.
Sliding Roof| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2345 | Motor Control Relay Stuck ON | Position failure (When the sliding roof ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | Sliding roof ECU (Sliding roof drive gear assembly) |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2345 | Motor Control Relay Stuck ON | Position failure (When the roof sunshade ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | Roof sunshade ECU (Sliding roof drive gear assembly) |
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC B2345 is not output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | CHECK DTC OUTPUT |
(a) Check the parts from which this DTC has been output.
| Result | Proceed to |
|---|---|
| DTC output from sliding roof ECU (sliding roof drive gear assembly) | A |
| DTC output from roof sunshade ECU (sliding roof drive gear assembly) | B |
| A | | REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) |
| B | | REPLACE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) |
Position Initialization Incomplete (B2343)
Remote Control System does not OperateLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/o Memory): Lost Communication with Main Body ECU (U0142)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U0142 Lost Communication with Main Body ECU No communication with main body ECU (multiplex network body ECU)
CAN communication system
Main body ECU (multiplex network body ECU)
CAUTION / NOTICE / HI ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Solar Sensor: Inspection
INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the K3 automatic light control sensor connector. *a Front view of wire harness connector (to Automatic Light Control Sensor) (b) Measure the voltage and resistance according to the value(s) in th ...