COMPONENTS
ILLUSTRATION
| *1 | NO. 2 SLIDING ROOF SIDE GARNISH LH | *2 | NO. 2 SLIDING ROOF SIDE GARNISH RH |
| *3 | NO. 3 SLIDING ROOF SIDE GARNISH LH | *4 | NO. 3 SLIDING ROOF SIDE GARNISH RH |
| *5 | NO. 4 SLIDING ROOF SIDE GARNISH LH | *6 | NO. 4 SLIDING ROOF SIDE GARNISH RH |
| *7 | SLIDING ROOF GLASS SUB-ASSEMBLY | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | CENTER SLIDING ROOF HOUSING MOUNTING BRACKET LH | *2 | CENTER SLIDING ROOF HOUSING MOUNTING BRACKET RH |
| *3 | FRONT SLIDING ROOF HOUSING MOUNTING BRACKET LH | *4 | FRONT SLIDING ROOF HOUSING MOUNTING BRACKET RH |
| *5 | REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH | *6 | REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH |
| *7 | ROOF RACK ASSEMBLY LH | *8 | ROOF RACK ASSEMBLY RH |
| *9 | SLIDING ROOF HOUSING ASSEMBLY | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for Sliding Roof | *B | for Roof Sunshade |
| *1 | NO. 2 ROOF WIRE | *2 | ROOM LIGHT BRACKET |
| *3 | SLIDE ROOF RAIL SUB-ASSEMBLY | *4 | SLIDING ROOF DRIVE GEAR ASSEMBLY |
| *5 | SLIDING ROOF DRIVE GEAR ASSEMBLY | *6 | SUNSHADE TRIM SUB-ASSEMBLY |
| N*m (kgf*cm, ft.*lbf): Specified torque | | MP grease |
ILLUSTRATION
| *1 | NO. 1 SLIDE ROOF PANEL SUB-ASSEMBLY | *2 | NO. 1 SLIDING ROOF SIDE GARNISH LH |
| *3 | NO. 1 SLIDING ROOF SIDE GARNISH RH | *4 | NO. 2 SLIDE ROOF PANEL SUB-ASSEMBLY |
| *5 | REAR SLIDING ROOF GARNISH | *6 | SLIDING ROOF HOUSING PANEL |
| N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
DisassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) The steering lock ECU (steering lock actuator or upper bracket assembly) stores DTCs when a malfunction occurs in the system. These DTCs can be confirmed by using the Techstream. NOTICE:
When using the Techstream with the engine switch off to confirm DTCs or Data ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below. Necessary Procedures After Parts Remove ...