DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1551 | HD Radio Tuner Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15B4 | CD Changer Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio receiver assembly |
| B15BA | XM Tuner Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
| B15F9 | UART Communication Malfunction(for A/C) | When either of the following conditions is met:
| Radio receiver assembly |
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
Lost Communication with Haptic Device (B1323-B1326)
Touch Pad Sensor Malfunction (B1559)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Smart Access System With Push-button Start (for Start Function): System Diagram
SYSTEM DIAGRAM Component Outline Engine switch
Transponder key amplifier
Turns on the power and starts the engine.
Contains a built-in transponder key amplifier to start the engine when the electrical key transmitter sub-assembly does not operate properly due to a depleted ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Outer Belt Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 seat outer belt assembly removal/installation are shown below. Necessary Procedure After Part ...