REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
| Initialize power window control system |
| |
HINT:
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
5. REMOVE REAR DOOR ARMREST COVER
Click here
6. REMOVE COURTESY LIGHT ASSEMBLY
Click here
7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
Click here
9. REMOVE REAR DOOR NO. 2 TRIM BRACKET
Click here
10. REMOVE REAR DOOR SERVICE HOLE COVER
Click here
11. DISCONNECT REAR DOOR WEATHERSTRIP
Click here
12. REMOVE REAR DOOR GLASS RUN
Click here
13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Click here
14. REMOVE REAR DOOR REAR GUIDE SEAL
Click here
15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Click here
16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
Click here
17. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
| (a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly. |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Precaution
PRECAUTION CAUTION:
Failure to carry out service procedures in the correct sequence could cause SRS parts to unexpectedly deploy and possibly lead to serious injuries. Furthermore, if a mistake is made when servicing SRS parts, they may fail to operate when required. Before performing servicing ( ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Combination Light Assembly (w/ Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY Click here 2. REMOVE REAR DOOR SCUFF PLATE Click here 3. REMOVE REAR DOOR INSIDE SCUFF PLATE Click here 4. ...