INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test.
PROCEDURE
1. INSPECT FRONT WIPER MOTOR AND LINK ASSEMBLY
| (a) Check the HI operation. (1) Connect a positive (+) lead from the battery to terminal 3 (L) and a negative (-) lead to terminal 4 (S+) and 1 (2S), and check that the front wiper motor and link assembly operates. NOTICE: Be careful not to get your fingers pinched between the parts (*b) shown in the illustration when the wiper motor and link assembly is operating. OK: Front wiper motor and link assembly operates at high speed (HI). If the result is not as specified, replace the front wiper motor and link assembly. |
|
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in P Squib (Dual Stage - 2nd Step) Circuit (B1815-B1818)
DESCRIPTION The front passenger squib 2nd step circuit consists of the airbag sensor assembly and instrument panel passenger airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Radio Antenna Cord (w/ Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...