DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C0 | GPS Antenna Connection Malfunction(short) | GPS Antenna Connection Malfunction(short) |
|
| B15C1 | GPS Antenna Connection Malfunction(break) | GPS Antenna Connection Malfunction(break) |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | INSPECT ANTENNA CORD SUB-ASSEMBLY |
(a) Remove the antenna cord sub-assembly.
w/o Rear No. 2 Seat: Click here
w/ Rear No. 2 Seat: Click here
(b) Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Antenna Cord Sub-assembly) |
| *a | Component without harness connected (Antenna Cord Sub-assembly) |
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-3 - B-1 | Always | Below 1 Ω |
| A-3a - B-1a | Always | Below 1 Ω |
| A-3 or B-1 - Body ground | Always | 10 kΩ or higher |
| NG | | REPLACE ANTENNA CORD SUB-ASSEMBLY |
|
| 3. | INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly.
Click here
(b) Inspet the navigation antenna assembly.
Click here
| OK | | REPLACE RADIO RECEIVER ASSEMBLY |
| NG | | REPLACE NAVIGATION ANTENNA ASSEMBLY |
Display Malfunction (B15A6,B15B0)
Speaker Output Short (B15C3)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fog Light Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Park / Neutral Position Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position. Standard Resistance: Tester Connection Condition Specified Condition 1 (RB ...