DTC CHECK / CLEAR
CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.
Chassis > Lane Control > Trouble Codes(e) Check for DTCs (Test Failed / Pending / Confirmed).
Techstream Display | Description |
---|---|
Test Failed | Represent malfunctions that were detected during the current trip. |
Pending | Represent malfunctions which have occurred since the DTCs were last cleared but have not been confirmed. |
Confirmed | Represent malfunctions which have occurred since the DTCs were last cleared and have been confirmed. (The number of trips since the DTC was stored may differ for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Clear DTCs.
Chassis > Lane Control > Clear DTCs(e) Clear the DTCs.
HINT:
Clearing the DTCs will also clear the freeze frame data.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Seat Switch(for Rear Side): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR POWER SEAT SWITCH LH (a) for LH Side: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 2 (FLDL) - 7 (E) FOLD switch pressed Below 100 Ω 2 (FLDL) - ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seat Cushion Heater (for Captain Seat Type): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat cushion heater removal/installation are shown below. Necessary Procedure After Parts Removed/I ...