FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a lane control system DTC is stored, the forward recognition camera stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.
Chassis > Lane Control > Trouble Codes(e) According to the display on the Techstream, select a DTC to display its freeze frame data.
Chassis > Lane Control| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| LDA Control | Lane control system control status | Prohibit or Permit | Prohibit: Control prohibited Permit: Control permitted | - |
| Turn Switch (Right) | Right turn signal switch status | OFF or ON | OFF: Right turn signal switch off ON: Right turn signal switch on | - |
| Turn Switch (Left) | Left turn signal switch status | OFF or ON | OFF: Left turn signal switch off ON: Left turn signal switch on | - |
| Vehicle Information (2WD/4WD) | - | - | - | Cannot be used |
| Vehicle Information (Conv/HV) | - | - | - | Cannot be used |
Dtc Check / Clear
Data List / Active TestLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Seat Switch(for Rear Side): Components
COMPONENTS ILLUSTRATION *A for 60/40 Split Seat Type RH Side - - *1 POWER SEAT SWITCH ASSEMBLY *2 REAR POWER SEAT SWITCH RH *3 RECLINING REMOTE CONTROL BEZEL RH - - ILLUSTRATION *A for 60/40 Split Seat Type LH Side - - *1 POWER SEAT SWITCH ASSEMBLY ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Drive Shaft Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...