INSTALLATION
PROCEDURE
1. INSTALL RADIO RECEIVER ASSEMBLY
2. INSTALL NAVIGATION ECU (w/ Navigation ECU)
3. INSTALL NO. 2 RADIO BRACKET
Click here
4. INSTALL NO. 1 RADIO BRACKET
Click here
5. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
6. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
7. INSTALL NO. 1 NAVIGATION WIRE (w/ Navigation ECU)
Click here
8. INSTALL CLOCK ASSEMBLY
Click here
9. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER
Click here
10. INSTALL LOWER INSTRUMENT FINISH PANEL SUB
Click here
11. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
13. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (a) Inspect the NORMAL or NORMAL CUSTOMIZE mode switch: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 8 (B) - 1 (GND) Combinati ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Stop Lamp Relay Actuator Stuck On (C13807E)
DESCRIPTION When any of the following conditions are met, the skid control ECU (brake actuator assembly) sets the drive output (STPO) ON which operates the stop light control relay (stop light switch assembly) and turns on the stop lights. Illumination Conditions:
Pre-collision brake is operating ...