REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air conditioning panel removal/installation are shown below.
Necessary Procedures after parts removed/installed/replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
(a) for Audio and Visual System:
(1) for 8 Inch Display:
Click here
(2) for 12.3 Inch Display:
NOTICE:
NOTICE:
Click here
(b) for Navigation System:
NOTICE:
NOTICE:
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
6. REMOVE LOWER INSTRUMENT FINISH PANEL SUB
Click here
7. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER
Click here
8. REMOVE CLOCK ASSEMBLY
Click here
9. REMOVE NO. 1 NAVIGATION WIRE (w/ Navigation ECU)
Click here
10. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
11. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
12. REMOVE NO. 1 RADIO BRACKET
Click here
13. REMOVE NO. 2 RADIO BRACKET
Click here
14. REMOVE NAVIGATION ECU (w/ Navigation ECU)
15. REMOVE RADIO RECEIVER ASSEMBLY
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction (B15F5)
DESCRIPTION This DTC is stored when items controlled by the air conditioning amplifier assembly cannot be customized via the navigation system vehicle customization screen. HINT: The air conditioning amplifier assembly controls the air conditioning system related items that are customizable via the ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lin Communication System: LIN Communication Bus Malfunction (B2325)
DESCRIPTION If the main body ECU (multiplex network body ECU) detects a communication error with an ECU connected to the door bus lines for 7 seconds or more, DTC B2325 will be stored. DTC No. Detection Item DTC Detection Condition Trouble Area B2325 LIN Communication Bus Malfunction ...