INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Press the A/C OFF switch.
(e) Turn the Techstream on.
(f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(g) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility| Tester Display |
|---|
| Servomotor Initialization |
HINT:
During initialization, the AUTO indicator light comes on, and then goes off when initialization has finished.
(h) According to the Techstream display, select the Exit switch to finish initialization.
How To Proceed With Troubleshooting
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rocker Panel Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY Click here 2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY Click here 3. REMOVE NO. 6 ROCKER PANEL ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Front Door Pressure Sensor RH (B166C,B166F)
DESCRIPTION The side collision sensor RH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor RH and rear airbag sensor RH. The door side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if ...