INSTALLATION
PROCEDURE
1. INSTALL BLOWER MOTOR CONTROL
(a) Install the blower motor control with the 2 screws.
(b) Connect the connector.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
4. INSTALL ROPE HOOK ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
6. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Click here
7. INSTALL FRONT DECK SIDE TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
Click here
8. INSTALL REAR SEAT OUTER TRACK BRACKET COVER RH
for 60/40 Split Seat Type:
Click here
for Captain Seat Type:
HINT:
Use the same procedure as for the LH side.
Click here
9. INSTALL REAR DOOR INSIDE SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
10. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
11. INSTALL REAR FLOOR FINISH PLATE
Click here
12. INSTALL REAR NO. 2 SEAT ASSEMBLY
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected. System See Procedure Lane Control System Pre-Collision System ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Propeller Shaft Assembly: Components
COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *C for TMC Made *D for TMMC Made *E for Type A *F for Type B *1 FRONT CENTER FLOOR COVER *2 FRONT FLOOR COVER LH *3 NO. 2 ENGINE UNDER COVER *4 PROPELLER SHAFT GUARD *5 WIRING HARNESS C ...