DISASSEMBLY
PROCEDURE
1. REMOVE COOLER COMPRESSOR BRACKET
| (a) Disengage the clamp. |
|
(b) Remove the screw and cooler compressor bracket.
2. REMOVE MAGNET CLUTCH ASSEMBLY
| (a) Secure the compressor and magnetic clutch in a vise between aluminum plates. |
|
(b) Using SST, hold the magnet clutch hub.
SST: 09985-00270
(c) Remove the bolt, magnet clutch hub and magnet clutch washer(s).
HINT:
There is no set number of magnet clutch washers that are used for adjusting clutch clearance.
| (d) Using a snap ring expander, remove the snap ring and magnet clutch rotor. NOTICE: Do not damage the seal cover of the bearing when removing the snap ring. |
|
(e) Disconnect the connector.
| (f) Using a snap ring expander, remove the snap ring and magnet clutch stator. |
|
Removal
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Transfer Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installe ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor System: Image from Camera for Panoramic View Monitor is Abnormal
DESCRIPTION The display signal from the rear television camera assembly is transmitted to the multi-display assembly via the parking assist ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative ( ...