CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK IF A PROPER CD IS INSERTED |
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
CD is normal.
HINT:
| NG | | END (CD IS FAULTY) |
|
| 2. | CHECK THAT CD IS INSERTED PROPERLY |
(a) Check if the CD is inserted upside down.
OK:
CD is properly inserted.
| NG | | SET CD PROPERLY |
|
| 3. | CLEAN CD AND RECHECK |
| (a) Disc cleaning (1) If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. OK: Malfunction disappears. NOTICE: Do not use a conventional record cleaner or anti-static preservative. |
|
| OK | | END (CD WAS DIRTY) |
|
| 4. | REPLACE CD AND RECHECK |
(a) Replace the CD with a new or known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
| OK | | END (CD WAS FAULTY) |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
CD cannot be Ejected
CD Sound SkipsLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, DCM (telematics transceiver)* or speaker ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at ...