Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the lighting system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

INSPECT CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

Result

Proceed to

CAN communication system DTCs are not output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

5.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result

Proceed to

Fault is not listed in Problem Symptoms Table.

A

Fault is listed in Problem Symptoms Table.

B

B

GO TO PROBLEM SYMPTOMS TABLE

A

6.

OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test

Click here

(b) Terminals of ECU

Click here

NEXT

7.

ADJUST, REPAIR OR REPLACE

NEXT

8.

CONFIRMATION TEST

NEXT

END

    System Diagram
    SYSTEM DIAGRAM ...

    Operation Check
    OPERATION CHECK INSPECT ILLUMINATED ENTRY SYSTEM OPERATION NOTICE: Perform this inspection with the customize parameters at the initial settings. HINT: Perform this inspection with the door switch of ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wiper And Washer System: Washer Fluid Level Warning Switch Circuit
    DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses of circuits related to this system before performing the following procedure. PROCEDURE 1. ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Master Module Horizontal Axis Misalignment (C1AC1)
    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0091