CUSTOMIZE PARAMETERS
CUSTOMIZE METER / GAUGE SYSTEM
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning or Display.
(5) Select the setting by referring to the table below.
NOTICE:
Be sure to record the current value before customizing.
Warning| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Flasher Sound Volume Adjustment | Function to change the flasher sound volume | Small | 10:Large,00:Medium,01:Small | Combination meter assembly |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| ODO Display Time After IG OFF Setting | Function to change the ODO display time after the engine switch is turned off | 30s | 00:30s,01:60s,10:600s,11:OFF | Combination meter assembly |
System Description
How To Proceed With TroubleshootingLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > 2gr-fks (emission Control): Fuel Tank Cap
InspectionINSPECTION PROCEDURE 1. INSPECT FUEL TANK CAP ASSEMBLY (a) Visually check that the fuel tank cap assembly and gasket are not deformed or damaged. If the result is not as specified, replace the fuel tank cap assembly. *a Gasket (b) Confirm that ID mark V is pri ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Mass Air Flow Meter: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below. Necessary Procedures After Parts ...