Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the meter / gauge system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

CHECK CAN COMMUNICATION SYSTEM*

(a) Check if CAN communication DTCs are output.

Click here

Result

Proceed to

CAN communication DTCs are not output.

A

CAN communication DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

5.

CHECK FOR DTC*

(a) Check for DTCs.

Click here

Body Electrical > Combination Meter > Trouble Codes

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A

6.

PROBLEM SYMPTOM CONFIRMATION

NEXT

7.

SYMPTOM SIMULATION

NEXT

8.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result

Proceed to

Fault is not listed in Problem Symptoms Table.

A

Fault is listed in Problem Symptoms Table.

B

B

GO TO PROBLEM SYMPTOMS TABLE

A

9.

CIRCUIT INSPECTION

NEXT

10.

REPAIR OR REPLACE

NEXT

11.

CONFIRMATION TEST

NEXT

END

    Customize Parameters
    CUSTOMIZE PARAMETERS CUSTOMIZE METER / GAUGE SYSTEM (a) Customizing with the Techstream (1) Connect the Techstream to the DLC3. (2) Turn the engine switch on (IG). (3) Turn the Techstream on. (4) Ente ...

    Initialization
    INITIALIZATION SCHEDULED MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (w/ Scheduled Maintenance Required Reminder) (a) Perform initialization using the multi-information display. (1) Turn the engine ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Radar Cruise Control System: Terminals Of Ecu
    TERMINALS OF ECU CHECK ECM HINT: As a waterproof connector is used for the ECM, voltage, resistance and waveform inspections cannot be performed. The voltage, resistance and waveform values are provided for reference only. (a) Measure the voltage and resistance according to the value(s) in the tabl ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure (C006328,C006396)
    DESCRIPTION for Optitron Meter Type: These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly). for TFT Meter Type: These DTCs are stored when the skid control ECU (bra ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0125