Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Status Signal Circuit

DESCRIPTION

This circuit sends a charging suspension signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle assembly. Based on this signal, the mobile wireless charger cradle assembly suspends or resumes wireless charging.

HINT:

The wireless charging system uses the same radio wave frequency that is used to perform verification of the electrical key transmitter sub-assembly. Therefore, when the electrical key transmitter sub-assembly verification is being performed, the certification ECU (smart key ECU assembly) sends a charging suspension signal to the wireless charging system to suspend charging.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the certification ECU (smart key ECU assembly), refer to the Registration.

Click here

PROCEDURE

(a) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition *1: When the engine switch is turned from off to on (ACC), the mobile wireless charger cradle assembly monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the engine switch is turned from off to on (ACC) again. *2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal (See page ). J78-7 (DIS) - Body ground For 5 seconds after turning engine switch from off to on (ACC)*1 4.5 to 6.0 V Device being charged Below 1 V Charging suspended due to smart entry and start system status*2 4.5 to 6.0 V

*a Component with harness connected (Mobile Wireless Charger Cradle Assembly)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

(a) Disconnect the J78 mobile wireless charger cradle assembly connector.

(b) Disconnect the R1 certification ECU (smart key ECU assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR