CUSTOMIZE PARAMETERS
NOTICE:
CUSTOMIZE PRE-COLLISION SYSTEM
(a) Customizing with the Multi-information Display
(1) Turn the engine switch on (IG).
(2) Enter the following menus: Settings Tab / Settings / Pre-collision System Settings.
(3) Select the setting by referring to the table below.
(4) Using the steering pad switches, change the customize settings.
Pre-collision System Settings| Display | Description | Setting | Default |
|---|---|---|---|
| PCS | Turns the pre-collision system function on/off. | ON/OFF | ON |
| Sensitivity | Sets the pre-collision system function warning sensitivity | Early/Middle/Late | Middle |
(b) Customizing with the Techstream
HINT:
The following items can be customized.
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Others.
(5) Select the setting by referring to the table below.
Others| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| PCS Function ON/OFF State Stored | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Forward recognition camera |
| PCS Warning Timing State Stored 1 | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Forward recognition camera |
| PCS Warning Timing State Stored 2 | Refer to the table below | Stored | $00:Not Stored,$01:Stored | Forward recognition camera |
| PCS Warning Timing State Stored 3 | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Forward recognition camera |
| Customize Setting | Description | Setting |
|---|---|---|
| PCS Function ON/OFF State Stored | Function to maintain the pre-collision system on/off setting when the engine switch is turned off and then to on (IG). | Not Stored: Not maintained (Pre-collision system always turns on) Stored: Maintained |
| PCS Warning Timing State Stored 1 | Function to maintain the sensitivity setting of the pre-collision system when the pre-collision system is turned off and then on. | Not Stored: Not maintained (Setting changes to "Middle") Stored: Maintained |
| PCS Warning Timing State Stored 2 | Function to maintain the sensitivity setting of the pre-collision system when the engine switch is turned off while the pre-collision system is on. | Not Stored: Not maintained (Setting changes to "Middle") Stored: Maintained |
| PCS Warning Timing State Stored 3 | Function to maintain the sensitivity setting of the pre-collision system when the engine switch is turned off while the pre-collision system is off. | Not Stored: Not maintained (Setting changes to "Middle") Stored: Maintained |
System Diagram
How To Proceed With TroubleshootingLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Radar Cruise Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
Before replacing the ECM, refer to Registration.
Click here
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information st ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio receiver assembly. If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly. If there is a short in the circuit, the same condition as when a sw ...