DESCRIPTION
The skid control ECU (brake actuator assembly) sends a stop light operation request signal to the stop light relay (semiconductor PWR integration ECU). If the skid control ECU (brake actuator assembly) detects a malfunction in the stop light relay (semiconductor PWR integration ECU) circuit, the forward recognition camera stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C142571 | Stop Light Relay Actuator Stuck | 3 seconds or more after the engine switch is turned on (IG), the forward recognition camera receives a stop light relay circuit malfunction signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more. | Vehicle stability control system |
PROCEDURE
| 1. | GO TO VEHICLE STABILITY CONTROL SYSTEM |
HINT:
If DTC C142571 is output by the pre-collision system, perform troubleshooting for the vehicle stability control system.
Click here
| NEXT | | END |
Vehicle Control History
Lost Communication with ECM/PCM "A" Missing Message (U010087,U012587,U012687,U012987)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use these procedures to troubleshoot the power steering system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. INSPECT BATTERY VOLTAGE (a) Turn the engine switch off. (b) Measure the voltage of the batt ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > 2gr-fks (starting): Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ST RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied to termi ...