INSPECTION
PROCEDURE
1. INSPECT SKID CONTROL BUZZER ASSEMBLY
(a) Make sure that there is no looseness in the locking part and connecting part of the connector. |
|
(b) Disconnect the skid control buzzer assembly connector.
(c) Check the connector and terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer assembly, and check that the buzzer sounds.
OK:
The skid control buzzer assembly sounds.
If the result is not as specified, replace the skid control buzzer assembly.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Immobiliser System: Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid (B279986)
DESCRIPTION If there is a communication malfunction between the ECM and ID code box (immobiliser code ECU), or when the communication ID codes do not match, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279986 Engine Immobiliser System Si ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Back Door Touch Sensor: Inspection
INSPECTION PROCEDURE 1. INSPECT POWER BACK DOOR SENSOR ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Not pressed 950 to 1050 Ω 1 - 2 Pressed Below 100 Ω I ...