REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU and switch assembly LH removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
| Position control ECU and switch assembly LH | Initialize position control ECU | Front Power Seat Control System (w/ Memory) | |
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
Click here
2. DISCONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY LH
Click here
3. REMOVE FRONT SEAT CUSHION SHIELD LH (for Standard Seat Type)
Click here
4. REMOVE INNER NO. 1 FRONT SEAT CUSHION SHIELD LH (for Sports Seat Type)
Click here
5. REMOVE FRONT SEAT CUSHION SHIELD LH (for Sports Seat Type)
Click here
6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Click here
7. REMOVE RECLINING POWER SEAT SWITCH KNOB
Click here
8. REMOVE POSITION CONTROL ECU AND SWITCH ASSEMBLY LH
| (a) Remove the 3 screws and position control ECU and switch assembly LH from the front seat cushion shield LH. |
|
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in Side Squib (RH) Circuit (B1820-B1823)
DESCRIPTION The front side squib RH circuit consists of the airbag sensor assembly and front seat airbag assembly RH. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front side squib RH ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Column Assembly: Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.
If the power steering ECU assembly is subjected to an impact, replace it with a new one.
Do not pull the wire harness.
Do not allow any moisture to come in ...