INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. INSTALL POSITION CONTROL ECU AND SWITCH ASSEMBLY LH
(a) Install the position control ECU and switch assembly LH to the front seat cushion shield LH with the 3 screws. |
|
2. INSTALL RECLINING POWER SEAT SWITCH KNOB
Click here
3. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Click here
4. INSTALL FRONT SEAT CUSHION SHIELD LH (for Standard Seat Type)
Click here
5. INSTALL FRONT SEAT CUSHION SHIELD LH (for Sports Seat Type)
Click here
6. INSTALL INNER NO. 1 FRONT SEAT CUSHION SHIELD (for Sports Seat Type)
Click here
7. CONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY LH
Click here
8. INSTALL FRONT SEAT ASSEMBLY LH
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Owners Manual > For safe use: Seat belts
Make sure that all occupants are wearing their seat belts before
driving the
vehicle.
Correct use of the seat belts
Extend the shoulder belt so that it
comes fully over the shoulder, but
does not come into contact with the
neck or slide off the shoulder.
Position the lap belt as low ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Tilt And Power Telescopic Steering Column System: IG Power Source Circuit
DESCRIPTION When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also receives engine switch signals via this circuit. WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Inspect ...