REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
Click here
2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
4. REMOVE DOOR ARMREST COVER
Click here
5. REMOVE COURTESY LIGHT ASSEMBLY
Click here
6. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION
Click here
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
| (a) Disconnect the connector. |
|
(b) Remove the 4 screws.
| (c) Disengage the 2 guides to remove the front No. 1 speaker assembly. |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Gear: Installation
INSTALLATION PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned. HINT: After adjusting the toe-in, tighten the lock nut. *a Matchmark 2. INSTALL TIE ROD ASSEMBLY RH HINT: ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Open in Outer Mirror Indicator(Slave) (C1AB5)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an open in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB5 Open in Outer Mirror Indicator(Slave) Both of the following conditions are met:
The b ...