COMPONENTS
ILLUSTRATION
| *1 | CUP HOLDER ASSEMBLY | *2 | NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH |
| *3 | NO. 1 SEAT ARMREST CAP | *4 | REAR SEAT ARMREST ASSEMBLY LH |
| *5 | REAR SEAT COVER CAP LH | *6 | REAR SEAT INNER RECLINING COVER LH |
| *7 | REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH | *8 | REAR SEAT UPPER RECLINING COVER LH |
| *9 | REAR SEATBACK BOARD CARPET ASSEMBLY LH | *10 | REAR SEATBACK COVER LH |
| *11 | RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH | *12 | SEAT HEATER ASSEMBLY |
| *13 | SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD | *14 | SEPARATE TYPE REAR SEATBACK COVER |
| *15 | SEPARATE TYPE REAR SEATBACK COVER WITH PAD | *16 | SEPARATE TYPE REAR SEATBACK PAD |
| *17 | REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY | *18 | HOG RING |
| *19 | TAG PIN | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | | N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Wheel: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below. Necessary Procedure After Parts Removed/ ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Back Door Closer Switch Malfunction (B2251)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, position switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these signals, the latch position of the back door lock assembly is determined. DTC No. Detec ...